Skip to content
Qanoon Digest

Amendment in SRO.565(I)/2006, dated 05.06.2006

SRO 641(I)/2018Amendments to earlier SROs

SRO 641(I)/2018 is a Customs SRO dated 24 May 2018, listed by FBR as "Amendment in SRO.565(I)/2006, dated 05.06.2006".

FBR publishes this SRO as scanned images, so the text below was transcribed by Qanoon Digest from the page images, with tables set out as tables. Check the official PDF before relying on any wording or figure.

Page 1

GOVERNMENT OF PAKISTAN
MINISTRY OF FINANCE, REVENUE AND ECONOMIC AFFAIRS
(REVENUE DIVISION)

Islamabad, the 24th May, 2018.

NOTIFICATION
(CUSTOMS)

S.R.O. 641(I)/2018.- In exercise of the powers conferred by section 19 of the Customs Act, 1969 (IV of 1969), the Federal Government is pleased to direct that the following further amendments shall be made in its Notification No. S.R.O 565(I)/2006, dated the 5th June, 2006, namely:-

In the aforesaid Notification, in the Table,-

(a) against S.No. 1, in column (1), under heading "Raw Materials", in column (3), in column (4), for the figure "3204.1700" the figures "3204.1710,3204.1720 and 3204.1790" shall be substituted; and

(b) against S.No. 5, in column (1) and entries relating thereto in column (2),(3),(4),(5) and (6), the following shall be substituted, namely,-

"5. Cold Rolled Coils (CRC) or Galvanized Iron (G.I) Coils Hot Rolled Coils (HRC) in prime quality of a width of 600 mm or more and thickness 4 mm or less 72.08 5% (i) If imported by sales tax registered manufacturers of CRC or G.I coils; (ii) Composite units also having pipe manufacturing facility shall not be allowed concessionary import of HRC; (iii) The machines for pickling, cold rolling, annealing, skin passing and re-coiling shall be capable of handling more than 600 mm wide coils. The quota determination by IOCO shall not be done on the basis of stand alone operation of different machines. It shall be done only after verification of complete manufacturing cycle in respect of CRC or G.I coils; and

Page 2

(iv) Concession shall not be available if CRC or GI coils so manufactured are supplied for manufacturing of pipes".

(c) against S. No. 7 in column (1), in column (5), for the figure "10" the figure "5" shall be substituted.

[C. No. 1(4) Tar-III/2016]

(Muhammad Zahid)
Additional Secretary

Which SROs does the title refer to?

  • SRO 565(I)/20065 June 2006Exemption from customs duty on import of raw materials, sub-components, components, sub-assemblies and assemblies, for manufacture of specified goods (Survey based).Exemptions and concessions

Related Customs SROs on amendments to earlier sros

All SROs on amendments to earlier sros

Report an error on this page